Keysight 53230A - Calculate2:Transform:histogram:clear

To Next Page

To Previous Page

CALCulate2:TRANsform:HISTogram:CLEar

Syntax

CALCulate2:TRANsform:HISTogram:CLEar[:IMMediate]

Description

This command clears the histogram data. If automatic scaling is enabled (CALCu-

late2:TRANsform:HISTogram:RANGe:AUTO ON set), the automatic scaling will be restarted.

Remarks

l The instrument clears the histogram data when the CALCulate2:TRANsform:HISTogram:POINts,

CALCulate2:TRANsform:HISTogram:RANGe:AUTO, CALCu-

late2:TRANsform:HISTogram:RANGe:AUTO:COUNt, CALCu-

late2:TRANsform:HISTogram:RANGe:LOWer, CALCulate2:TRANsform:HISTogram:RANGe:UPPer

commands are sent, when CALCulate2:TRANsform:HISTogram:STATe ON is sent, when the meas-

urement function is changed, when the INITiate:IMMediate, MEASure? or READ? commands are

executed, when the CALCulate2:TRANsform:HISTogram:CLEar command is executed, after a Factory

Reset (*RST command) or after an Instrument Preset (SYSTem:PRESet command).

Examples

The following example clears the histogram data.

CALC2:TEAN:HIST:CLE

Other manuals for Keysight 53230A