MMEMory:STORe:DATA
Syntax
MMEMory:STORe:DATA RDG_STORE, <file>
Description
This command stores all measurements in the reading memory to the specified data file. The file name
optionally includes the folder name and the file extension.
Remarks
l The file extension (.csv or .dat) specifies the data format. If .csv is specified, the data is stored in comma-
separated value (CSV) format, with one measurement per line in ASCII format. If .dat is specified, the
data is stored as binary 64-bit floating point values in little-endian byte order. The default data format is
CSV.
l The format for <file> is "[[<drive>:]<path>]<file_name>", where <drive> can be INTernal or USB, and
<path> is a folder path.
o
INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
o
If <drive> is specified, <path> is interpreted as an absolute folder path. Absolute paths begin with a "\"
or "/" and start at the root folder of <drive>.
o
If <drive> is omitted, <path> is relative to the folder specified by the MMEMory:CDIRectory command.
Relative paths must not begin with "\" or "/".
o
Folder and file names cannot contain the following characters: \ / : * ? " < > |
o
The combination of folder and file name cannot exceed 240 characters.
o
The destination folder must exist and cannot be marked as hidden or system.
o
If the destination file exists, it will be overwritten, unless marked as a hidden or system file.
Examples
The following example stores all measurements in the reading memory to the data file MyFreqMeas.csv in
the root directory of the internal flash file system.
MMEM:STOR:DATA RDG_STORE,"INT:\MyFreqMeas"
See Also
MMEMory:CATalog:DATA?
MMEMory:CDIRectory
Keysight 53220A/53230A Programmer's Reference 307
MMEMory:STORe:DATA
To Next Page
Loading...
