Keysight 53230A - Calculate2:Transform:histogram:count

To Next Page

To Previous Page

CALCulate2:TRANsform:HISTogram:COUNt?

Syntax

CALCulate2:TRANsform:HISTogram:COUNt?

Description

This query returns the number of measurements collected since the last time the histogram data was

cleared.

Remarks

l You can read the histogram data at any time.

l The instrument clears the histogram data when the CALCulate2:TRANsform:HISTogram:POINts,

CALCulate2:TRANsform:HISTogram:RANGe:AUTO, CALCu-

late2:TRANsform:HISTogram:RANGe:AUTO:COUNt, CALCu-

late2:TRANsform:HISTogram:RANGe:LOWer, CALCulate2:TRANsform:HISTogram:RANGe:UPPer

commands are sent, when CALCulate2:TRANsform:HISTogram:STATe ON is sent, when the meas-

urement function is changed, when the INITiate:IMMediate, MEASure? or READ? commands are

executed, when the CALCulate2:TRANsform:HISTogram:CLEar command is executed, after a Factory

Reset (*RST command) or after an Instrument Preset (SYSTem:PRESet command).

Return Format

The query returns the number of measurements counted in the current histogram data in the form +100.

Examples

The following example returns the number of measurements used to compute the current histogram

data.

CALC2:TRAN:HIST:COUN?

Typical Response: +73

Other manuals for Keysight 53230A