Keysight 53230A - Status:operation:enable

STATus:OPERation:ENABle
Syntax
STATus:OPERation:ENABle <enable>
STATus:OPERation:ENABle?
Description
This command enables bits in the enable register for the Standard Operation Register group. The selec-
ted bits are then reported to the Status Byte.
For more information on the SCPI Status System, see the Status System Diagram.
Parameters
Name Type Range of Values Default Value
<enable> Numeric A decimal value which corresponds to the
binary-weighted sum of the bits in the
register (see table below).
This is a required parameter
Remarks
l
The following table lists the bit definitions for the Standard Operation Register.
Bit Num-
ber
Bit Name Decimal
Value
Definition
0
Calibrating
1 Instrument is performing a calibration.
1 Running on Battery 2 Instrument is powered from the internal battery.
2 Battery Critical 4 Internal battery power is critically low.
3 Not Used 8 (Reserved for future use)
4 Measuring 16 Instrument is initiated, and is making, or about to make a meas-
urement.
5 Waiting for Trigger 32 Instrument is waiting for a trigger.
6 Not Used 64 (Reserved for future use)
7 Not Used 128 (Reserved for future use)
8 Not Used 256 (Reserved for future use)
9 Internal Reference 512 Set to 1 while the instrument is using its internal reference; set to 0
when using an external reference.
STATus:OPERation:ENABle
384 Keysight 53220A/53230A Programmer's Reference