SYSTem:SECurity:IMMediate
Syntax
SYSTem:SECurity:IMMediate
Description
This command clears and sanitizes all instrument memory except for the instrument firmware and cal-
ibration constants. This command is typically used to clear all memory before removing the instrument
from a secure area.
This command is not recommended for use in routine applications because of the pos-
sibility of unintended loss of data.
Remarks
l
This command will not clear a USB storage device, if attached.
l The command clears and sanitizes all user files on the internal file system, including stored state inform-
ation.
l This command clears and sanitizes all stored state information (see *SAV).
l All I/O settings such as the GPIB address and IP address are returned to their factory settings.
l This command initializes all instrument settings to their Factory Reset (*RST command) values.
Example
The following example clears all instrument memory.
SYST:SEC:IMM
See Also
*SAV
*RCL
*RST
Keysight 53220A/53230A Programmer's Reference 455
SYSTem:SECurity:IMMediate
To Next Page
Loading...
