<function> Gate Gource Depends on measurement function. See the MEASure? com-
mands for the different measurement functions for details.
Gate Start Source IMMediate
Gate Start Delay TIME, 0 sec
Gate Stop Source IMMediate
Gate Stop Holdoff TIME, 0 sec
Gate Start and Stop Slope NEGative
External Gate Source Gate In/Out BNC
Burst Gate Auto Enabled
Burst Gate Delay 0.0
Burst Gate Time 1 uS
Narrow Pulse Mode Disabled
Samples per Trigger
1 sample, except for the MEASure:ARRay:TSTamp? command,
which sets this value to the <count> parameter for this command.
Trigger Count 1 trigger
Trigger Delay 0 sec
Trigger Source IMMediate
Trigger Slope NEGative
Timestamp Rate 1.0E6
CALCulate subsystems Disabled, including the individual calculate functions. The other parameters
are unchanged.
Reference Oscillator Unchanged
STATus, DATA, and FORMat sub-
systems
Unchanged
Auto-level Frequency Unchanged
Measurement Timeout Unchanged
Using the MEASure? Command
The following example shows how to use the MEASure? command to make a measurement. This example
configures the instrument for frequency measurements, internally triggers the instrument to take a meas-
urement, and then transfers the measurement to the instrument output buffer. The default resolution is
used for the measurement.
MEAS:FREQ? 1.0E6
Typical Response: +1.03460000000000E+006
MEASure Subsystem Introduction
238 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
