>1.1E-9 to ≤1.1E-8 1 msec
>1.1E-8 to ≤1.1E-7 100 usec
>1.1E-7 to ≤1.1E-6 10 usec
>1.1E-6 1 usec
Return Format
The query returns a single measurement. The format of the measurement is controlled by the FORMat
Subsystem commands.
Examples
The following example configures the instrument for pulse repetition interval measurements on channel 3
using default parameters, makes one measurement, and then transfers the measurement to the instru-
ment output buffer.
MEAS:FREQ:PRI? (@3)
Typical Response: +1.00230000000000E-007
The following example configures the instrument for 10-digit pulse repetition interval measurements of
an approximately 1.2 MHz pulsed signal on channel 3, makes one measurement, and then transfers the
measurement to the instrument output buffer.
MEAS:FREQ:PRI? 0.833E-6,1e-16,(@3)
Typical Response: +8.33337934613473E-007
See Also
CONFigure?
FETCh?
READ?
SENSe:FREQuency:GATE:SOURce
SENSe:FREQuency:GATE:TIME
MEASure:FREQuency:PRI?
250 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
