Keysight 53230A - Page 411

To Next Page

To Previous Page

l For the query form, specify "CURRent" (default) to read the dynamic default gateway currently being

used by the instrument. Specify "STATic" to read the default gateway currently stored in non-volatile

memory within the instrument (may not be the actual address used by the instrument if DHCP is enabled).

l The default gateway is stored in non-volatile memory, and does not change when power has been off,

after a Factory Reset (*RST command), or after an Instrument Preset (SYSTem:PRESet command).

l The gateway is set to "0.0.0.0" (no subnetting) when the instrument is shipped from the factory or after a

SYSTem:SECurity:IMMediate command.

Return Format

The query returns the default gateway address in the form "nnn.nnn.nnn.nnn" (the quotes are also

returned).

Examples

The following example sets the default gateway address.

SYST:COMM:LAN:GAT "198.105.232.1"

SYST:COMM:LAN:UPD

The following example returns the default gateway address currently being used by the instrument.

SYST:COMM:LAN:GAT? CURR or SYST:COMM:LAN:GAT?

Typical Response: "0.0.0.0"

Other manuals for Keysight 53230A