Keysight 53230A - Page 478

Calibration Errors
The following errors indicate failures that may occur during a calibration. Refer to the
Keysight53220A/230AService Guide for more information.
+701, "Calibration error; security defeated"
+702, "Calibration error; calibration memory is secured"
+703, "Calibration error; secure code provided was invalid"
+704, "Calibration error: secure code too long"
+705, "Calibration error; calibration aborted"
+706, "Calibration error: provided value out of range"
+707, "Calibration error: computed correction factor out of range"
+708, "Calibration error: signal measurement out of range"
+709, "Calibration error: no calibration for this function"
+710, "Calibration error: full scale correction out of range"
+711, "Calibration error: calibration string too long"
+712, "Calibration failed"
+713, "Channel 3 calibration signal not detected"
+714, "Channel 3 calibration signal power level error"
+715, "Channel 3 calibration signal frequency error"
+716, "Channel 3 calibration signal is not CW"
+717, "Channel 3 calibration timeout occurred"
+720, "Auto-calibration failed; input signal detected"
+740, "Calibration data lost: secure state"
+740, "Calibration information lost: count, security state, security code, string"
+741, "Calibration data lost: string data"
+742, "Calibration data lost: corrections"
+748, "Calibration memory write failure"
+750, "Calibration data not restored"
SCPI Error Messages
478 Keysight 53220A/53230A Programmer's Reference