Krone Big Pack 890 XC - Compressed Air Connections for the Compressed Air Brake

Commissioning
105
Pos: 97.9 /Übersc hriften/Übersc hriften 2/F-J/HH ydraulische n Stützfuß anba uen @ 193\m od_13832154143 02_78.docx @ 1646685 @ 2 @ 1
8.1 Attaching Hydraulic Parking Jack
Pos: 97.10 /BA/Ers tinbetriebna hme/Großpacken pressen/Bei A usführung hydraulisc her Stützfuß @ 193\ mod_1383214866 332_78.doc x @ 1646602 @ @ 1
With hydraulic parking jack design.
Pos: 97.11 /BA/Ers tinbetriebna hme/Großpacken pressen/Hydr aulischen Stützfuß anbauen Bild @ 193\ mod_1383214808 495_78.doc x @ 1646573 @ @ 1
Fig.
46
Pos: 97.12 /BA/Ers tinbetriebna hme/Großpacken pressenHydra ulischen Stützfuß anbauen T ext T1 @ 326\ mod_1425977 815714_78.doc x @ 2502941 @ @ 1
• Attach the crane to the suspension point (I) on the drawbar.
• To raise the support jack (2), slightly raise the drawbar, shift support jack entirely upward
and secure with socket pin (3).
• To lower the drawbar on the ground, place sufficiently dimensioned square blocks under the
front drawbar beam (4) and lower the drawbar.
• Lay the hydraulic hoses (5) to the outside.
• To remove the support jack, screw out the four screws (6), remove the support jack and put
it down to the side.
• Insert the hydraulic support jack (7) at the same position.
• To raise the hydraulic support jack, attach the support jack using the crane (II) and raise it.
• Mount screws (6) and detent edged washers and secure with detent edged washers and
nuts.
Tighten the screws with corresponding tightening torque.
Pos: 97.13 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1