Krone Big Pack 890 XC - Setting the Lateral Plunger Blades

Settings
278
Pos: 109.13 /Übers chriften/Übersc hriften 3/A- E/A/Auflagedruc k der Tasträder einstellen @ 1 57\mod_1364 377544872_7 8.docx @ 13872 72 @ 3 @ 1
19.2.1 Setting the Ground Pressure of the Guide Wheels
Pos: 109.14 /BA /Einstellungen/Pic k-up / Roll enniederhalter/A uflagedruck der T asträder 1290 HDP II Bild Ausführung ohn e Schneidwer k @ 157\mod_1 364377057422 _78.docx @ 1387153 @ @ 1
a
Fig.
179
Pos: 109.15 /BA /Sicherheit/8. Vor aussetzungen/H andlungsanweis ung für alle Mas chinen/Ha ndlungsanweis ung: Maschine stillse tzen und sic hern @ 27 4\mod_14043 65253849_78.d ocx @ 2065151 @ @ 1
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Pos: 109.16 /BA /Einstellungen/Pic k-up / Roll enniederhalter/A uflagedruck der T asträder Hinw eis Feder gl eich einstellen @ 157\mod_13 64378097424_78. docx @ 138 7474 @ @ 1
Note
Increasing dimension a => Ground pressure of the guide wheels becomes less
Reducing dimension a => Ground pressure of the guide wheels becomes greater
Adjust dimension “a” equally for both springs (right and left sides of the machine).
Pos: 109.17 /BA /Einstellungen/Pic k-up / Roll enniederhalter/A uflagedruck der T asträder Te xt Ausführung oh ne Schneid werk @ 157\mo d_13643781579 35_78.docx @ 1387503 @ @ 1
• Open protective cover.
• Increase or reduce the dimension a via nut (2).
• Close protective cover.
Pos: 109.18 /BA /Einstellunge n/Pick-up / Roll enniederhalter/Hin weis Voreinstell ung Auflagedr uck Tasträder @ 302\mod_ 14139774692 32_78.docx @ 235 3997 @ @ 1
Note
The pre-setting dimension for the pick-up in the highest raised position is a = 285 mm.
Pos: 109.19 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1