Krone Big Pack 890 XC - Checking Packer Coupling; Moving Packer Strip into Position

Settings
282
Pos: 109.37 /Übers chriften/Ü berschriften 3/F-J/HH öhe der Na deln am Knoter einstellen @ 2 6\mod_124 5326395230_78.d ocx @ 260901 @ 3 @ 1
19.4.2 Setting the height of the needles on the knotter
Pos: 109.38 /BA /Einstellungen/Gr oßpackenpr esse/Nadeleinst ellungen/Hö he der Nadeln am Knoter Bild Ei nfachknoter un d Doppelknoter @ 26\mod_124 5326467168_ 78.docx @ 2 60925 @ @ 1
BPXC0154
3
4
5
7
a
1
b
6
1
2
3
4
5
7
a
b
6
2
2
Fig.
183
Standard knotter
Double knotter
Pos: 109.39 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Höhe d er Nadeln am K noter einstelle n Text @ 21\ mod_1239091 936086_78.doc x @ 228832 @ @ 1
Note
Only make adjustments with the twine threaded in!
• Trigger the tying process manually with machine at a standstill
• Turn the needle yoke on the flywheel manually upwards into working position until the lower
roll in the needle tip is located above the cleaners (6) of the tappet (2) (I)
• Tighten the flywheel brake to lock the needles (4) in this position
Note
The distance "a" from the lower edge of the needle roll to the upper edge of the cleaning disc
with twine must be between 1 and 3 mm.
If this dimension ”a” is not reached, it can be corrected by adjusting the screws (7). When the
needles enter the knotter, they should touch the knotter on the right in the driving direction.
Pos: 109.40 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1