Krone Big Pack 890 XC - Transfer Gearbox

Settings
321
Pos: 109.98.16 /Üb erschriften/Üb erschriften 3/ K-O/NNullsteller einstellen @ 2 72\mod_14 03255157802_78. docx @ 204 9702 @ 3 @ 1
19.19.3 Adjusting the zeroizing device
Pos: 109.98.17 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih e/Nullsteller ein stellen Bild BP 870 @ 272\ mod_1403255 205278_78.docx @ 2049730 @ @ 1
A
Fig.
226
Pos: 109.98.18 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih e/Nullsteller ein stellen @ 27 2\mod_14030 82433259_78.doc x @ 2048405 @ @ 1
Adjusting the zeroizing device
The zeroizing device is set to the zero position, see chapter Settings "Adjusting the Variable Fill
System" ->"Zero position".
• Relieve the spring (15).
• Loosen the screw (1).
• Swivel the zeroizing device (9) up manually.
• Swivel the cam disc (7) manually as far as possible in direction A and hold it there.
• Swivel the zeroizing device (9) down and turn the eccentric plate (2) until the roller (8) is
positioned in the lower area (B) of the zeroizing device.
• To secure the eccentric plate so that it cannot move, tighten the bolt (1).
• Release the cam disc.
The roller for the zeroizing device swivels into the upper area (C) of the zeroizing device.
• Tension the spring (15), see chapter Settings "Adjusting the spring of the zeroizing device".
• Adjust the rubber pad for the zeroizing device, see chapter Settings "Adjusting the rubber
pad for the zeroizing device".
Checking the clearance of the ratchet
• Rotate the packer once completely by turning the flywheel manually in the direction of
operation.
The ratchet must not move during the entire operation.
Pos: 109.98.19 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1