Krone Big Pack 890 XC - Maintenance - Lubrication

Settings
334
Pos: 109.138 /BA/ Wartung/Schn eidwerk/Einzel messersicheru ng entlasten @ 2 75\mod_1 404467559772_7 8.docx @ 20 69451 @ @ 1
Releasing the single blade locking device
• Shut down and safeguard the machine, see chapter Safety -> Safety routines "Shutting
down and safeguarding the machine".
• Attach the special tool (4) to the upper or knife selection (1, 2).
CAUTION! Risk of injury due to spring pressure on the special tool. If you release it too soon,
you can injure yourself.
• Turn the special tool (4) until the cams on the upper and lower knife selection are in the (
) position.
Pos: 109.139 /BA/ Wartung/Schn eidwerk/Mess erkassette herauszi ehen @ 27 5\mod_14044 67519024_78.d ocx @ 206942 3 @ @ 1
Removing the knife drawer (7)
• To remove the knife drawer, unlock the locking lever (3) and pull the knife drawer out
sideways as far as the stop.
Pos: 109.140 /La yout Module /----------------Leerzeile 5 Pt.-------------------- @ 120\mod_134259291 8145_0.doc x @ 1092566 @ @ 1
Pos: 109.141 /BA/ Wartung/Schn eidwerk/Mess erwelle entriegeln @ 275\ mod_14044674064 52_78.docx @ 2069395 @ @ 1
Unlocking the blade shaft
• To unlock the blade shaft, move the locking lever (5) to position ( ).
Pos: 109.142 /La yout Module /----------------Leerzeile 5 Pt.-------------------- @ 120\mod_134259291 8145_0.doc x @ 1092566 @ @ 1
Pos: 109.143 /BA/ Wartung/Schn eidwerk/Mess er entnehmen / ein setzen @ 275\ mod_140 4467247194_78 .docx @ 206936 7 @ @ 1
Removing/replacing blades
CAUTION! Danger from sharp blades. Wear gloves.
• Remove the blade (6) vertically upwards.
• Insert the new blade vertically from above.
Pos: 109.144 /La yout Module /----------------Leerzeile 5 Pt.-------------------- @ 120\mod_134259291 8145_0.doc x @ 1092566 @ @ 1
Pos: 109.145 /BA/ Wartung/Schn eidwerk/Mess erwelle verriegeln @ 275\mo d_14044671699 17_78.docx @ 2069339 @ @ 1
Locking the blade shaft
• To lock the blade shaft, move the locking lever (5) to position ( ).
• Push in the knife drawer until the locking lever (3) automatically catches in place.
• Insert the special tool into the holder on the machine
Pos: 109.146 /La yout Module /----------------Leerzeile 5 Pt.-------------------- @ 120\mod_134259291 8145_0.doc x @ 1092566 @ @ 1
Pos: 109.147 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_119 6175311226_0. docx @ 4165 @ @ 1