Terminal – Machine Functions [Medium/Comfort Version Electronics]
168
Pos: 103.52 /BA /Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grundbild H andbetrieb/ Anzeigen im Hau ptfenster/Anzeige n im Hauptf enster (III) rechte Spalte HS B aureihe @ 351\ mod_143695 9136836_78.doc x @ 2631535 @ @ 1
Right column
Bale channel flap
pressure in bar or PSI
(depending on selected
system of units)
In manual mode.
• The value (1) in the bar display
indicates the current bale channel flap
pressure.
• The value (2) in the bar display and
the marks (2) in the bar display
indicate the set target bale channel
flap pressure.
• The value (2) is touch-sensitive.
In automatic mode.
• The value (1) in the bar display
indicates the current force of
pressure.
• The value (2) in the bar display and
the mark (2) in the bar display indicate
the set target force of pressure.
• The display may fluctuate
considerably. The control only
functions when the packer is
supplying crops to the piston.
• The bale channel flap pressure is
automatically set by the system based
on the measured plunger force.
• The value (2) is touch-sensitive.
• The arrows have three different sizes,
numbered from 1 to 3.
• The arrows (left/right) indicate to the
driver the side he/she should correct
towards and by how much when
driving over the swath to ensure that
the bale chamber is evenly filled.
• The direction indicator can be
adjusted, see chapter Terminal –
Menus, Menu 2 "Sensitivity of
direction indicator".
• The value (3) indicates the current
bale length.
• The value (4) indicates the set target
bale length.
• The value (4) is touch-sensitive.
• The value (5) indicates the current
number of small bales.
• The value (6) indicates the set target
number of small bales.
• The value (6) is touch-sensitive.
• A horn sounds briefly after each small
bale is bound.
• When the entire bale is ready, the
horn sounds longer and louder.
Pos: 103.53 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1