Settings
306
Pos: 109.92.5 /Ü berschriften/Ü berschriften 3/A- E/E/Einstellung Garnhalter @ 47\mod_12 85054111875_78. docx @ 455 539 @ 3 @ 1
19.15.9 Setting of twine retainer
Pos: 109.92.6 / BA/Einstellung en/Großpacke npresse/Knoter/D oppelknoter/G arnhalter Doppel knoter Bild @ 2 4\mod_1241 416073040_78. docx @ 243 437 @ @ 1
Fig.
Pos: 109.92.7 / BA/Einstellunge n/Großpackenpr esse/Knoter/Garn halter Text Einf achknoter / D oppelknoter R aspe @ 47\ mod_1285053 711171_78.docx @ 455513 @ @ 1
Setting the twine driver
The function of the twine driver (5) depends on the position of its indentation opposite the twine
disc cleaner (7). The twine driver (5) has been set to a = 0-2 mm as a default setting ex works.
• If the indentation on the twine driver (5) is positioned too far forward (clockwise), the
twine cannot be snagged by the twine driver as it is being guided along by the
needle.
• On the other hand, if the indentation on the twine driver (5) is positioned too far back
(anticlockwise), the twine strand may become wound up on the knotter hook or it
may not be possible for it to be snagged by the knotter tongue.
Setting the twine driver (5)
The indentation of the twine driver (5) has to be located at the position shown.
Then:
• Undo the nut (4) until the nut (4) is flush with the thread end of the auger
• Undo the auger by means of a slight knock against the nut (4)
• Adjust to a = 0-2 mm by turning the auger
• Tighten nut (4)
Note
At least two tying processes must be performed to check for the correct position of the
indentation.
Pos: 109.92.8 / Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
