Krone Big Pack 890 XC - Setting the Holding Force of the Twine Retainer

Operation
274
Pos: 107.62 /BA /Bedienung /Groß packenpresse/ Bindevorgang von Hand ausl ösen @ 170 \mod_1369744 285660_78.docx @ 1468817 @ 2 @ 1
18.9 Initiating the Tying Process Manually
Fig.
175
It is only necessary to trigger the tying process manually when performing maintenance,
adjustment and repair tasks.
Prerequisite:
– The tractor is disconnected.
Initiating the tying process:
• Swivel the safety lever (1) down.
• Move lever (2) to the rear to initiate the tying process.
Pos: 107.63 /BA /Bedienung /Groß packenpresse/ Bindevorgang von Hand beend en @ 170\ mod_1369831 994895_78.docx @ 1471160 @ 2 @ 1
18.10 Finishing Tying Process Manually
3
a
Fig.
176
Prerequisite:
– The tractor is disconnected.
– The tying process has been initiated; refer to chapter Operation “Initiating Tying Process
Manually”.
A tying process consists of a rotation of the cam track.
• Turn the flywheel (3) manually in the working direction (a) until the trigger roller (1) slides in
the recess of the cam disc (2).
Knotter gear in idle position
The knotter gear is in idle position if the trigger roller (1) is in the recess of the cam track (2) of
the knotter gear.
Pos: 107.64 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1