Krone Big Pack 890 XC - Menu 13-1 Customer Counter

Safety routines 5
Shutting down and safeguarding the machine 5.1
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
21
5 Safety routines
5.1 Shutting down and safeguarding the machine
WARNING
Crushing hazard due to movement of machine or machine parts
If the machine is not stopped, machine or machine parts may move unintentionally. Thus
there is a risk of serious injuries or death.
 Before leaving the cabin: Shut down and safeguard the machine.
To shut down and safeguard the machine:
 Put machine down on a firm, fixed and level ground.
 Switch off the drives and wait until the trailing parts have come to standstill.
 Switch off the tractor engine, remove the ignition key and take it with you.
 Secure the tractor against rolling away with wheel chocks.
 Secure the machine against rolling away with the parking brake and wheel chocks.
 Using the flywheel brake, secure the machine to prevent unpredictable movements of
machine parts.
5.2 Securing raised machine and machine parts against lowering
WARNING
Crushing hazard due to movement of machine or machine parts
If the machine or machine parts are not secured against lowering, the machine or machine
parts may roll, fall or sag. Thus people could be squeezed or killed.
 Lower the raised machine parts.
 Shut down and safeguard the machine, refer to page21.
 Before working on or under raised machine parts: Secure machine or machine parts
against lowering by means of hydraulic shut-off device (e.g. stop cock) on machine side.
 Before working on or under raised machine parts: Safely support machine or machine
parts.
In order to safely support the machine or machine parts:
 To support, only use suitable and sufficiently dimensioned materials that do not break or
yield.
 Bricks and hollow blocks are not suitable for safely supporting the machine and machine
parts. Therefore they must not be used.
 Car jacks are also not suitable for safely supporting the machine and machine parts. They
must not be used, as well.