Krone Big Pack 890 XC - Presetting Threaded Rod; Stop for the Feeler Rocker

Settings
285
Pos: 109.45.7 / BA/Einstellunge n/Großpackenpr esse/MutiBale/Ei nstellung Verrieg elung (Ra hmen) @ 24\ mod_12414986 09820_78.doc x @ 245279 @ 3 @ 1
19.5.4 Setting the locking (frame)
Fig.
186
• Set the support tube (10) so that the distance between the locking (11) and the support tube
(10) is Z = 15-35 mm
Pos: 109.45.8 / BA/Einstellunge n/Großpackenpr esse/MutiBale/Ei nstellung Verrieg elungen der N adelschwing en @ 24\mod _1241501736 055_78.doc x @ 245306 @ 3 @ 1
19.5.5 Setting the lockings of the needle yoke
Fig.
187
In order to ensure a safe lock of the second needle yoke (13), the locking (11) (as shown in the
figure above) has to have a distance of U = 3 – 7 mm to the pin (12) of the needle yoke (14).
Pos: 109.45.9 / Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0. docx @ 4165 @ @ 1