Commissioning
111
Pos: 97.29 /BA/Ers tinbetriebna hme/Gelenkwelle/ Großpacken pressen/Gelenkwelle ByPyGelenkw elle kürzen T eil 2 @ 17 0\mod_13697 28951081_78.d ocx @ 1467935 @ @ 1
Fig.
• Connect the machine without universal shaft to the tractor
• Move the machine to the narrowest position (driving around curves).
• Switch off the engine of the tractor, remove the ignition key and secure the tractor and the
machine from rolling away.
• Attach the PTO shaft halves on tractor side and on machine side.
Determining the overlap (X)
• Determine the dimension “X”.
• The determined dimension „X+2cm“ must be transferred to the protective tubes and to the
section tubes of the PTO shaft halves.
CAUTION!
The carry over dimension X+2cm must not pass the grease emersion bore holes (a) at
the section tube inside as the end piece is destroyed when shortening.
Increase the dimension x+2cm by 2cm if it passes the grease emersion bore holes.
• Shorten the protective tubes and the section tubes, deburr them from the outside and from
the inside and remove the chips.
• To obtain a complete Teflon coating, melt the Teflon coating at the end of the section tubes
somewhat with the lighter.
Pos: 97.30 /La yout Module /-------- -------Seitenumbruch---------------- @ 0\mod_1196175311226 _0.docx @ 4 165 @ @ 1
To Next Page
Loading...
