Krone Big Pack 890 XC - Checking and Maintaining Tyres

Settings
311
Pos: 109.96.10 /A bkürzungen /A bkürzungen s prachneutral/Gr oßpackenpress e/Big Pack 129 0 HDP @ 32\ mod_12530895 01874_0.docx @ 309828 @ @ 1
Big Pack 1290 HDP
Pos: 109.96.11 /B A/Einstellung en/Großpackenpre sse/Presskolb eneinstellung/Ei nstellung der Preßkolben messer BP 1290 HD P / 4x4 @ 279 \mod_140 5341656863_ 78.docx @ 21497 53 @ @ 1
• Release the flywheel brake and turn the flywheel manually in the direction of operation until
the blades are above the counterblade.
• To secure the baling ram, tighten the flywheel brake.
• Measure the dimension "a" between the blade and counterblade.
If the dimension "a" = 2 to 4 mm, the blades are correctly set.
If the dimension "a" is not 2 to 4 mm, spacer washers must be inserted or removed.
• Release the flywheel brake and turn the flywheel manually in the direction of operation until
the blades are freely accessible.
• To secure the baling ram, tighten the flywheel brake.
• Loosen the bolts on the blade and add or remove spacer washers until the
dimension "a" = 2 to 4 mm.
• Tighten the screws on the blade.
• Release the flywheel brake and turn the flywheel manually in the direction of operation until
the blades are above the counterblade.
• To secure the baling ram, tighten the flywheel brake.
• Measure the dimension "a" between the blade and counterblade.
If the dimension "a" = 2 to 4 mm, the blades are correctly set.
If the dimension "a" is not 2 to 4 mm, repeat the process until the dimension "a" = 2 to 4
mm.
Pos: 109.96.12 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1