KRONE ISOBUS Terminal [Medium/Comfort Version Electronics]
154
Pos: 103.7.1 /Üb erschriften/Üb erschriften 2/F-J/ IISOBUS Shor tcut Button @ 364\mod_144 0571658458_ 78.docx @ 2680 236 @ 2 @ 1
11.1 ISOBUS Shortcut Button
Pos: 103.7.2 /B A/Sicherheit/2. V orangestellte W arnhinweise/ Warnung - ISO BUS Shortc ut Button @ 364\mo d_144066269 3340_78.docx @ 2682480 @ @ 1
WARNING!
The ISOBUS Shortcut Button is not an EMERGENCY STOP switch. If the ISOBUS
Shortcut Button is mistaked for the EMERGENCY STOP switch, there is danger to life.
When actuating the ISOBUS Shortcut Button, activated machine functions are deactivated.
Process oriented procedures are executed until the end. Therefore machine parts may
continue to run after ISOBUS Shortcut Button is actuated. This may lead to injuries.
In no event the ISOBUS Shortcut Button intervenes in tractor functions. This means that
neither the universal shaft function nor the hydraulic function is affected. Therefore the
machine can continue to run after ISOBUS Shortcut Button is actuated. This may lead to
injuries.
• Never use the ISOBUS Shortcut Button as an EMERGENCY STOP switch.
Pos: 103.7.3 /B A/Info-Center/CCI-I SOBUS-Ter minal/Module f ür Beipack/I SOBUS Short Cut Button/ISOBU S Shortcut Butto n_wird betätigt _Comprima_F ortima_Ultima @ 364\mod _1440576607502_ 78.docx @ 26 80358 @ @ 1
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
ESC
IBT000055
1
ISB
Fig.
When actuating the ISOBUS Shortcut Button (1) of the terminal which is of the pushbutton
design, a stop command is sent to the ISOBUS. This instruction is evaluated by the connected
ISOBUS machine in order to deactivate activated machine functions. Process oriented
procedures are executed until the end.
Actuating ISOBUS Shortcut Button
• Press the ISOBUS Shortcut Button (1).
The above message appears in the display. The job computer blocks all hydraulic functions on
machine side as well as the electronic tying device.
Pos: 103.7.4 /B A/Info-Center/CCI-I SOBUS-Ter minal/Module f ür Beipack/ISO BUS Short Cut Button/ISOBUS Short Cut But ton_Funktion maschinenseitig bl ockiert_BiG P ack HS Baur eihe @ 377\m od_14431757 25103_78.doc x @ 2736723 @ @ 1
The job computer blocks the following functions on the machine side:
• Start the knotter motor.
• Start knotter cleaning.
Depending on the machine configuration:
• Raise/lower the blade bar.
• Move the bale ejector forwards/backwards.
• Automatic bale ejection.
• Raise/lower the bale chute.
• Switch to MultiBale.
Pos: 103.7.5 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
