Krone Big Pack 890 XC - Lighting; Using the Safety Chain

Commissioning
114
Pos: 97.35 /BA/Ers tinbetriebna hme/Gelenkwelle/ Großpacken pressen/Gelenkwelle ByPyVerschi ebeweg (Üb erlappung) ermitt eln @ 170\ mod_136972 8715377_78.doc x @ 1467771 @ @ 1
Determining the displacement path (overlapping)
X1
X2
Fig.
55
• Lay the both PTO shaft halves in front of one another, the outer section tube is in front of
the inner section tube.
• Determine dimension X
1
.
• Slide PTO shaft halves into one another as far as they will go and attach a marking (2) at
the end of the protective tube outside.
• Connect the universal shaft on tractor and on machine side, move the machine to the
farthest position (straight-ahead driving).
• Determine dimension X
2
.
Calculating the displacement path “V” (overlapping):
V = X
1
- X
2
The displacement path (overlapping) must be at least V ≥ 220 mm.
Check the shortened universal shaft when driving around curves.
• Perform the right and left turn slowly with the tractor. In this process, mind the marking (2).
The protective tube outside must not touch the marking (2) in the narrowest position
(turn with maximum steering angle and simultaneous driving up and driving down a
slope). If the protective tube outside touches the marking, shorten the both PTO shaft
halves by the same length as described above until the protective tube outside does not
touch the marking any more.
Pos: 97.36 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1