Settings
325
Pos: 109.98.40 /B A/Einstellung en/Großpackenpre sse/Variables Füllsyste m VFS/BiG PACK 1290 HDP II/Tas tschwinge versetzen Hin weis 2 1290 HDP II @ 170\mod_ 13699034542 90_78.docx @ 14 72081 @ @ 1
Note
After moving the feeler rocker, check or if necessary adjust the following settings.
• Check the zero position (see chapter Settings “Zero Position”)
• Check the actuating sensitivity and adjust if, if necessary; refer to chapter Settings “Setting
the Actuating Sensitivity”.
• Check the stop for feeler rocker and adjust it, if necessary; refer to chapter Settings
“Setting Stop Feeler Rocker”.
• Check the absorbing mechanism and adjust it, if necessary, refer to chapter Settings
„Setting the Absorbing Mechanism“.
Pos: 109.98.41 /Üb erschriften/Üb erschriften 3/A- E/A/Anschlag T astschwinge einstellen @ 1 07\mod_13 34223782493_78. docx @ 96443 3 @ 3 @ 1
19.19.8 Adjusting the feeler rocker stop
Pos: 109.98.42 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/ BiG PACK 12 90 HDP II/A nschlag Tastschwi nge einstell en Bild BiG PAC K 1290 HDP I I @ 170\mod _1369905088718 _78.docx @ 1472190 @ @ 1
Fig.
Pos: 109.98.43 /B A/Einstellung en/Großpac kenpresse/Varia bles Füllsyste m VFS/BiG PACK 1 290 HDP II/A nschlag Tastsch winge einstellen Text BiG PACK 1290 HDP II @ 170\mod_ 13699054901 16_78.docx @ 1472219 @ @ 1
• Loosen the nuts (19) and move the stop to the rear.
• Pull the feeler rocker (1) manually to the rear to initiate the VFS system.
• Turn the flywheel manually in the working direction until the grooved ball bearing (5) is on
the highest position (area “C”).
In this position, the tines (18) of the feeler rocker must be outside (a) the packer tray (11).
• Check if the tines (18) are outside (a) the packer tray (11).
If the tines are not outside the packer tray:
• Correct the length of the threaded rod until the tines are outside the packer tray.
Setting the stop:
• Move the stop (10) until the dimension “E” is 2 mm.
• Tighten the nuts (19).
Pos: 109.98.44 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1