Krone Big Pack 890 XC - Menu 15-2 Actuator Test

8 Terminal – machine functions [Medium Plus/Comfort Plus Electronics]
8.6 Calling up road travel screen
38
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
Æ When the terminal is switched on, the machine starts in manual mode with a target bale
channel flap pressure of 50bar.
651 8
19
0
19
0
kg
0,0
20
4 cm
38 %
94 / 240 cm
20
4 cm
108 bar
94 / 240 cm
651 8
19
0
19
0
kg
0,0
AUTO
EQG000-029
8.6 Calling up road travel screen
EQG000-026
To call up the road travel screen, the following preconditions must be fulfilled:
ü The bale chute has been raised.
ü None of the hydraulic functions, which are operated via the terminal, is actuated.
ü The PTO shaft is switched off.
If the above mentioned preconditions are not fulfilled, the terminal changes automatically to
road travel screen after approx. 60 seconds.
8.7 Changing to automatic mode
 Press
.
Æ The display shows the
AUTO
icon (automatic mode).
8.8 Changing to manual mode
 Press
AUTO
.
Æ The display shows the
icon (manual mode).