Maintenance – lubrication
374
Pos: 157.20 /BA /Wartung/Großp ackenpressen/ Schmierung / Sc hmierplan/L aufrollen der Messerh ebel absch mieren @ 24\mod_1 241695903648 _78.docx @ 247898 @ 2 @ 1
25.4 Lubricating the rollers for the blade lever
Fig.
• Lower the cutting system with the tractor hydraulics (with the comfort electronics system:
Activate the tractor hydraulics and hold down “Lower blade bar” on the control unit display
or on the machine buttons until the cutting system is lowered all the way down)
• Remove the ignition key and turn off the electrical system on the control unit
• Apply the flywheel brake
• Secure the tractor and machine against rolling
• Unlock the cutting system half and remove it as far as the stop (right hand and left hand
machine side)
• Lubricate all grease nipples for the rollers of the blade levers
• Push in the half of the cutting system on the side (right hand and left hand side of the
machine) until the locking lever (3) snaps into place by itself
• Raise the cutting system hydraulically
Pos: 157.21 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
