Krone Big Pack 890 XC - Adjusting the Baling Ram; Setting the Baling Ram Blades

Settings
276
Pos: 109.1 /Übersc hriften/Üb erschriften 1/A-E/ Einstellungen @ 0\mod_119 9868783862_78.d ocx @ 3614 1 @ 1 @ 1
19 Settings
Pos: 109.2 /BA/Sic herheit/2. Vora ngestellte W arnhinweise/WARNUN G - Nic htbeachtung d er grundlegend en Sicherheits hinweise alte For m @ 254\mod _13974857935 75_78.docx @ 1953347 @ @ 1
WARNING!
If the basic safety instructions are not followed, people may be seriously injured or
killed.
• To avoid accidents, the basic safety instructions in the chapter Safety must have been
read and followed, see chapter Safety "Basic safety instructions".
Pos: 109.3 /BA/Sic herheit/2. Vora ngestellte W arnhinweise/WARNUN G - Nic htbeachtung d er Sicherheitsrouti nen alte For m @ 273\mod _1404117435996 _78.docx @ 2058712 @ @ 1
WARNING!
If the safety routines are not adhered to, people may be seriously injured or killed.
• To avoid accidents, the safety routines in the chapter Safety must be read and followed,
see chapter Safety "Safety routines".
Pos: 109.4 /BA/Ei nstellungen/Groß packenpres se/Folgende Arb eitsschritte werden in diese m Kapitel beschri eben BiG PAC K 1290 HDP II @ 325\mod _1425894441 756_78.docx @ 25 01787 @ @ 1
The following work steps are described in this chapter:
– Setting the working height of the pick-up.
– Setting the ground pressure of the guide wheels.
– Driving with fixed pick-up.
– Setting the holding-down device.
– Setting the lateral needles.
– Checking / setting the needle yoke brake.
– Checking / setting the position needles - baling ram.
– Checking / setting the upper needles.
– Checking / setting the twine bars.
– Checking / setting the twine bars to the channel slot.
– Checking the overreach of the twine bars at the second knot.
– Tensioning / releasing the upper needle.
– Tightening / releasing the twine bar shaft.
– Setting the knotter shaft brake.
– Setting the twine brake.
– Setting the knotters.
– Setting the baling ram.
– Setting the packer to the baling ram.
– Checking the packer coupling.
– Setting the Variable Filling System.
– The default setting of flywheel brake.
– Setting the cutting length, in case of full equipping of blade cassette
– Setting the cutting length, depending on the blade fitting in the blade cassettes.
Pos: 109.5 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1