Krone Big Pack 890 XC - Pick-Up Gearbox

Settings
322
Pos: 109.98.20 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem V FS/HS-Baureih e/Gummipuff er Nullsteller einst ellen @ 309\ mod_141708 3054491_78.doc x @ 2393996 @ 3 @ 1
19.19.4 Setting the Rubber Buffer on the Zero Adjuster
Fig.
227
Prerequisite:
– The zero adjuster is set in zero position, refer to chapter Settings “Setting the Variable
Filling System” -> “Zero Position”.
Setting the rubber buffer on the zero adjuster
• Make sure that the dimension A is 0 to 2 mm. To do this, place or remove washers under
the rubber buffers (16).
Pos: 109.98.21 /Üb erschriften/Üb erschriften 3/F-J /FFeder N ullsteller einstelle n @ 272\mo d_140325497 7399_78.docx @ 2 049669 @ 3 @ 1
19.19.5 Adjusting the spring in the zeroizing device
Pos: 109.98.22 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih e/Einstellung der Feder des Nulls tellers Bil d BP 870 HS Baur eihe @ 272\ mod_14032422 80555_78.doc x @ 2049330 @ @ 1
Fig.
228
Pos: 109.98.23 /B A/Einstellung en/Großpackenpre sse/Variables Füllsyste m VFS/BiG PACK 4 x4/Nullsteller Fe der Text @ 10 7\mod_13 34225201961_78. docx @ 96485 6 @ @ 1
The spring (15) is adjusted in the zero position (see Settings section “Zero position”).
The spring has been set to A = 185 mm at the factory.
Check and, if required, adjust dimension A:
• Pretension the spring (15) to a dimension of "A" = 185 mm
Pos: 109.98.24 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1