Krone Big Pack 890 XC - Menu 5-2 Correction Value for Moisture Measurement

Terminal – Machine Functions [Medium/Comfort Version Electronics]
178
Pos: 103.66.12 /Üb erschriften/Üb erschriften 2/A- E/B/Ballenlä nge einstelle n (Hand- und Aut omatikbetrieb) @ 381\mod_1 44404800507 9_78.docx @ 2750 052 @ 2 @ 1
14.24 Setting bale length (manual and automatic mode)
Pos: 103.66.13 /B A/Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grun dbild Handbetri eb/Ballenlänge ei nstellen Hand betrieb Bild H S Baureihe @ 3 52\mod_1437 479408613_7 8.docx @ 263601 2 @ @ 1
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
1/2
Fig.
105
Pos: 103.66.14 /B A/Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grun dbild Handbetri eb/Ballenlänge ei nstellen Hand- und Automati kbetrieb @ 38 1\mod_1444048 499984_78.d ocx @ 275008 3 @ @ 1
Note
(BP 890;1270;1290)
The bale length can be set in the range from 1000 - 2700 mm (39 - 106 inches).
(BP 1290 HDP; BP 4x4)
The bale length can be set in the range from 1000 - 3200 mm (39 - 126 inches).
Note
The bale length can be changed at any time. It is not recommended to change over the bale
length at the end of the bale, as the knotter could then be actuated too late.
Setting the bale length
• Change the value, see chapter Terminal – Menus, "Changing the value".
Pos: 103.66.15 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1