Settings
320
Pos: 109.98.12 /Üb erschriften/Üb erschriften 3/ K-O/NNullstellu ng (VFS-Syst em) @ 107\ mod_13342252511 67_78.docx @ 964914 @ 3 @ 1
19.19.2 Zero position (VFS system)
Pos: 109.98.13 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/ BiG PACK 4x4/N ullstellung Bil d @ 107\ mod_13342253 27515_78.doc x @ 964942 @ @ 1
Fig.
Pos: 109.98.14 /B A/Einstellung en/Großpackenpre sse/Variables Füllsyste m VFS/HS-Baureih e/Nullstellung T ext @ 306\m od_141621564 8293_78.docx @ 2378959 @ @ 1
Turn the packer manually in the working direction by rotating the flywheel until the roll (8) has
engaged in the zero adjuster (9) (VFS is in the zero position now).
Note
The zero position is correctly set when
• the anvil (4) rests against the setting screw (3)
• the centre of the roll of the grooved ball bearing (5) rests on the trigger ratchet by
B = 5 – 8 mm away from the tip of the trigger ratchet (6)
• the feeler rocker (1) shows a distance of C = 5 – 10 mm to the edge of the packer
tray (11)
Check setting and correct it as follows, if necessary:
• Set the setting screw (3) until the centre of the roll of the grooved ball bearing (5) is 5 –
8 mm away from the tip of the trigger ratchet (6) and rests on the trigger ratchet
Note
If dimension B cannot be set, check absorbing mechanism and set it, if necessary (refer
to chapter Settings “Setting the Absorbing Mechanism”).
• Set threaded rod (2) until the feeler rocker (1) shows a distance of C = 5 – 10 mm to the
edge of the packer tray (11)
Pos: 109.98.15 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1
To Next Page
Loading...
