Maintenance Compressor
370
Pos: 151 /BA/War tung/Kompress or/Kompressor- Ölstand Bil d @ 193\mod_13826830 06840_78.doc x @ 1642404 @ @ 1
Fig.
1) Oil dip stick / oil filling hole
Pos: 152 /BA/War tung/Ölko ntrolle_Wechsel/Öl kontrolle / Öl wechsel Inter vall: siehe Kapitel Wartung „Wartungst abelle“ @ 1 34\mod_13 50483605921_7 8.docx @ 11881 15 @ @ 1
Interval for oil level check and oil change: refer to chapter Maintenance “Maintenance Table”
Pos: 153 /BA/War tung/Ölkontroll e_Wechsel/Ölqu alität/Ölmeng e: siehe Kapitel Technische Da ten der Maschi ne @ 371\ mod_1441958 324612_78.docx @ 2710777 @ @ 1
Oil quality/amount of oil: refer to chapter entitled Technical Data of Machine “Operating
Materials”
Pos: 154 /BA/War tung/Kompress or/Kompressor- Ölstand prüf en / nachfüllen Text @ 193\m od_13826829 23612_78.doc x @ 1642375 @ @ 1
Clean the oil dip stick with a non-fibrous cloth.
Oil level check:
• Thoroughly clean the area around the oil dip stick.
• Pull out the oil dip stick, clean it and insert it completely.
• Pull out the oil dip stick and check the oil level.
The oil level is OK if it is between the markings „(Y)“ and „(X)“.
• Insert the oil dip stick.
Top up oil if the oil level is below the marking “(Y)”.
To do this:
• Top up the oil via filling hole until the marking “(X)” is reached.
• Insert the oil dip stick.
Pos: 155 /BA/War tung/Kompress or/Kompressor- Ölwechs el Text @ 193\m od_138268311 3127_78.docx @ 1642463 @ @ 1
Oil change:
Collect escaping oil in a suitable container.
• Pull out the oil dip stick and clean it.
• Screw out oil drain plug and drain the oil.
• Screw in oil drain plug and tighten it securely.
• Top up new oil via oil filling hole until the marking “(X)” is reached.
• Insert the oil dip stick.
Pos: 156 /Layou t Module /---------------Seitenumbruch---------------- @ 0\mod_11961753 11226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
