Krone Big Pack 890 XC - Adjusting the Transfer Mechanism

Settings
328
Pos: 109.100 /BA/ Einstellungen /Großpackenpresse /Einstellung d er Schwungr adreinigung ( nur bei Big Pack 890) @ 24\m od_12414397 33852_78.doc x @ 244873 @ 2 @ 1
19.20 Setting the flywheel cleaning (only on BiG PACK 890)
Fig.
234
Even minor accumulations of dirt inside the flywheel (1) can result in imbalances. For this
reason, you should regularly check the setting of the plastic rail (2). If the gap between the
flywheel and the plastic rail is too big, loosen the nuts (5) on the support (4) and push the plastic
rail in the oblong holes (1) up to the flywheel. Tighten the nuts again.
Pos: 109.101 /BA/ Einstellungen /Großpackenpresse /Grundeinstellu ng der Ban dbremse (Schw ungrad) @ 325\ mod_142 5902922399_78.d ocx @ 250184 5 @ 2 @ 1
19.21 Default Setting of Belt Brake (Flywheel)
BPXC0168
1
a
Fig.
235
The belt brake is mounted on the left-hand side of the flywheel. If the braking effect is no longer
sufficient when actuating the belt brake, it can be readjusted by extending the spindle (1).
Basic setting:
Machine
Dimension a
870
335.6 mm
890, 1270, 1290, 4x4, 1290 HDP II
186 mm
1290 HDP:
195 mm
Pos: 109.102 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_119 6175311226_0. docx @ 4165 @ @ 1