Krone Big Pack 890 XC - Error Message from Sensors 522100 - 522299

9 Terminal – menus [Medium Plus/Comfort Plus Electronics]
9.6 Changing mode
52
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
Æ The setting is saved and the input mask closes.
9.6 Changing mode
It is possible to select between different modes in individual menus.
 To select the next mode, press
.
 To select the previous mode, press
.
 To save, press
.
Æ An acoustic signal sounds, the set mode is saved and the
icon is briefly displayed in
the upper line.
 To leave the menu, press
.
9.7 Menu 1 "Knotter"
EQ001-003 / EQ001-005
ü The menu level is called, refer to page49.
 To open the menu, press
.
Æ The display shows the "Knotter" menu.
The "Knotter" menu is divided into the following sub-menus depending on the machine
configuration:
Icon Designation
Menu 1-1 "Correction value for bale length", refer to page53
Menu 1-2 "Knotter signal", refer to page53
Menu 1-3 "Knotter monitoring", refer to page54
Menu 1-4 "Blowing interval", refer to page55
Menu 1-5 "Blowing time", refer to page55
Menu 1-9 "Calibrate MultiBale", refer to page56