Krone Big Pack 890 XC - Adjusting the Feeler Rocker Stop

Settings
291
Pos: 109.53 /Übers chriften/Übersc hriften 2/K- O/OObernadel pr üfen / einstell en @ 271\ mod_1402649470 033_78.doc x @ 2042940 @ 2 @ 1
19.8 Checking / Setting Upper Needle
Pos: 109.54 /BA /Einstellunge n/Großpackenpress e/Bindegarn ei nfädeln/Doppel knoter @ 20 \mod_1239010 038066_78.doc x @ 226971 @ @ 1
Double knotter
Pos: 109.55 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Oberna del prüfen / eins tellen Vorra ussetzung @ 271\mod_14026 49988061_78.d ocx @ 2043 118 @ @ 1
Prerequisite:
– The upper needle is tensioned, see chapter Settings "Tensioning/relieving the upper
needle".
– The twine locking shaft is tensioned, see chapter Settings "Tensioning/relieving the twine
locking shaft".
Pos: 109.56 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Oberna del prüfen / eins tellen BiG PAC K 890/1270/ 1290/1290HD P/4x4 @ 281\ mod_14060354 33229_78.doc x @ 2164372 @ @ 1
5
6
4
Fig.
191
• Make a catch hook (1).
• In order to simulate a tied bale, pull the twine (2) with the catch hook out of the bale channel
and fix it on the top on the bale channel flap with a shaft (3) (screwdriver).
• To tighten the tensioning arm (4), pull back the upper twine (5) in front of the twine eye (6).
• Initiate the baling process manually when the machine is at a standstill.
• Turn the flywheel manually to the working direction until the upper needle (7) raises.
• Turn the flywheel manually in the direction of working until the needle (8) nearly touches the
upper twine (5).
At this point in time, the upper twine (5) must be centred in front of the needle (8).
If the upper twine is not centred in front of the needle:
• If the upper twine is centred in front of the needle, align the upper needle by using a
mounting lever.
If the upper twine is centred in front of the needle:
Fig.
192
• Turn the flywheel manually to the direction of working until the trigger roller (9) is in the
recess of the knotter gear (idle position).
The knotting process is finished now. The upper twine moves slightly to the right while the
flywheel continues to rotate. This is structurally determined as the needle guides the upper
twine into the blade lever.
Pos: 109.57 /BA /Einstellungen/Gr oßpackenpress e/Garnriegel/Gar nriegel prüf en einstellen Einf ührtext @ 170\ mod_136 9723043694_78.d ocx @ 146744 3 @ 2 @ 1