Safety
21
Pos: 19.20 /Übersc hriften/Überschrif ten 3/A-E/ B/Betriebssic herheit: Technisc h einwandfrei er Zustand @ 187\mod_138 0012216128_78.d ocx @ 160687 7 @ 3 @ 1
3.4.8 Operational safety: Technically perfect condition
Pos: 19.21 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Betriebssich erheit - Betrie b nur nach ordnu ngsgemäßer Inbetriebnahme @ 176\mod_ 137285446472 8_78.docx @ 1 506530 @ @ 1
Operation only when the machine has been started up correctly
If the machine is not started up correctly according to these operating instructions, the
operational safety of the machine is not ensured. As a result, accidents may occur and people
may be seriously injured or killed.
• Do not use the machine unless it has been started up correctly, see chapter Start-up.
Pos: 19.22 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Betriebssich erheit - Technis ch einwandfrei er Zustand d er Maschine @ 176\mod_1372 854718958_7 8.docx @ 15065 59 @ @ 1
Technically perfect condition of the machine
Improper maintenance and adjustment may affect the operational safety of the machine and
cause accidents. As a result, people may be seriously injured or killed.
• Perform all maintenance and adjustment work according to the chapters Maintenance and
Adjustment.
• Before performing any maintenance or adjustment work, shut down and safeguard the
machine, see chapter Safety "Shutting down and safeguarding the machine".
Pos: 19.23 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Betriebssich erheit - Gefahr durch Schäd en an der Maschin e @ 176\mo d_137285643 0313_78.docx @ 1506618 @ @ 1
Danger resulting from damage to the machine
Damage to the machine may impair the operational safety of the machine and cause accidents.
As a result, people may be seriously injured or killed. The following parts of the machine are
particularly important for safety:
– Brakes
– Steering
– Safety devices
– Connecting devices
– Lighting
– Hydraulic system
– Tyres
– Universal shaft
If there are doubts about the operational safety of the machine, for example due to leaking
consumables, visible damage or an unexpected change to the driving behaviour:
• Shut down and safeguard the machine, see chapter Safety, "Shutting down and
safeguarding the machine".
• Immediately eliminate potential causes of damage, for example heavy soiling, or tighten
slack screws.
• Determine the cause of damage according to these operating instructions, see chapter
Malfunctions – Cause and remedy.
• If possible, repair the damage according to these operating instructions.
• In the case of damage which may affect operational safety and cannot be repaired
according to these operating instructions: Have damage repaired by a qualified service
centre.
Pos: 19.24 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
