Krone Big Pack 890 XC - Examples of Emergency Manual Activation; Raising; Lowering the Roller Chute

Settings
317
Pos: 109.96.34 /B A/Einstellung en/Großpackenpre sse/Press kolbeneinstellung/Pr esskolben in P osition bringen Text T2 alle HS TYpen außer 1 290 HDP @ 192\mod_138209 2469255_78.doc x @ 1638910 @ 3 @ 1
19.18.4 Moving Baling Ram into Position
13
14
4
X
3
5
12
6
Fig.
222
Prerequisite:
– The packer strip is in position, refer to chapter Settings “Moving Packer Strip into Position”
Procedure
• Remove the protection (13) of the chain coupling.
• Remove the roller chain (14) from the chain coupling.
• Release the flywheel brake.
• Move the piston rod (3) to extended position (a) (rear dead point) by turning on the flywheel
(12) in the working direction.
• Tighten the flywheel brake.
• Position the roller chain (14) of the chain coupling and secure it.
• Install the guard (13) on the chain coupling.
• Remove the mounting lever.
Checking the setting:
• Release the flywheel brake
• Turn through the machine manually in the working direction one complete time on the
flywheel until the piston rod (3) is in its extended position (a) (rear dead point).
The packer (1) is correctly set to the baling ram (2) if the piston rod (3) is in its extended position
(a) and the large packer strip roller (4) running in front of the feeder strip (5) is X=6cm under the
control window (6). If this is not the case, set packer to baling ram again (refer to chapter
Settings “Setting Packer to Baling Ram“).
Pos: 109.97 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1