Machine Description
64
Pos: 55.51 /Übersc hriften/Üb erschriften 3/P-T/S Schneid werkantrieb @ 192\ mod_1382011 621479_78.d ocx @ 1635994 @ 3 @ 1
5.8.3 Cutting System Drive for the Design with XC Cutting System
Pos: 55.52 /BA/Be dienung /Groß packenpresse/Üb erlastsicherunge n / Kupplu ngen / Sternr atsche / Scherschr aube/Überl astsicherung d es Schneidwer ks und der Pic k-up, Ausführung H S mit Schnei dwerk @ 136\ mod_1353063 267793_78.docx @ 1213945 @ @ 1
Fig.
A cam-type clutch is located over the cutting system gearbox.
The cam-type clutch protects cutting system and pick-up drive against load peaks.
Pos: 55.53 /Übersc hriften/Überschrif ten 3/P-T/P Pick-up Antrie b @ 155\mo d_13636768292 27_78.docx @ 1373624 @ 3 @ 1
5.8.4 Pick-up Drive
Pos: 55.54 /BA/Be dienung /Groß packenpresse/Üb erlastsicherunge n / Kupplu ngen / Sternratsc he / Scherschr aube/Überlastsic herung d er Pick-up Bild mit Legende HS M aschinen @ 1 91\mod_13 81831704061_7 8.docx @ 16318 94 @ @ 1
Fig.
Pos: 55.55 /BA/Be dienung /Groß packenpresse/Üb erlastsicherunge n / Kupplu ngen / Sternr atsche / Scherschr aube/Überl astsicherung d er Pick-up, b ei Ausführung mit Schneidwer k @ 155\mod_13 63675037552_78. docx @ 137 3392 @ @ 1
For design with cutting system:
A cam-type clutch, star ratchet (1) design, can be found on the chain drive of the pick-up.
The cam-type clutch protects the chain drive of the pick-up against load peaks.
Pos: 55.56 /BA/Be dienung /Groß packenpresse/Üb erlastsicherunge n / Kupplu ngen / Sternratsc he / Scherschr aube/Überlastsic herung d er Pick-up, b ei Ausführung oh ne Schneidwer k @ 155\mod_1 36367494829 7_78.docx @ 137 3364 @ @ 1
For design without cutting system
A cam-type clutch, star ratchet (1) design, is located on the lower pick-up gearbox on the lower
end of the drive PTO shaft.
The cam-type clutch protects the pick-up drive against load peaks.
Pos: 55.57 /BA/Be dienung /Groß packenpresse/Üb erlastsicherunge n / Kupplu ngen / Sternratsc he / Scherschr aube/Hinweis Üb erlastkup plung angesproch en @ 136\ mod_1353062689 925_78.doc x @ 1213829 @ @ 1
Note
As soon as the overload coupling responds, stop the tractor and reduce the speed until the
machine has cleared itself again. The overload coupling now automatically resumes its work.
An error message appears in the display of the control unit.
Pos: 55.58 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
