1 Information on This Document
1.5 How to use this document
6
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
• Check all screws on the machine for firm attachment, refer to page6. (INFORMATION: If
you use this document in electronic form, you get to the stated page by clicking on the link.)
• For further information, please refer to the operating instructions of the universal shaft
manufacturer.
1.5.2 Information on direction
Information on direction in this document such as front, rear, right and left always applies in
direction of travel of the machine.
1.5.3 Term “machine”
Throughout the rest of this document, the “large square baler” will also be referred to as the
“machine”.
1.5.4 Figures
The figures in this document do not always represent the exact machine type. The information
which refers to the figure always corresponds to the machine type of this document.
1.5.5 Scope of the document
In addition to standard equipment, accessories kits and versions of the machine are described
in this document. Your machine may deviate from this document.
1.5.6 Means of representation
Icons in the text
The following means of representation (icons) are used to present the text more clearly:
This arrow characterizes an action step. Several arrows in a row identify a sequence of
actions to be performed step by step.
This icon identifies a prerequisite that has to be fulfilled to perform an action step or a
sequence of actions.
This arrow marks the intermediate result of an action step.
This arrow identifies the result of an action step or sequence of actions.
This bullet point identifies an enumeration. If the bullet point is intended, it identifies the
second level of the enumeration.
Icons in figures
The following icons can be used in the figures:
Icon Explanation
Reference sign for parts
Position of a part (e.g. move from pos. I to pos. II)
To Next Page
Loading...
