Machine Description
56
Pos: 55.15 /BA/Ma schinenbeschr eibung/Maschi nenübersicht/Gr oßpackenpress en/Beschreib ung Pressvorga ng @ 153\ mod_1363008350 826_78.doc x @ 1359371 @ 2 @ 1
5.4 Description of the Baling Process
When switching on the terminal, the terminal shows at first the manual mode basic screen.
Starting with an empty bale channel
In manual mode, pre-set the target bale channel flap pressure to 50 bar / 725 PSI (in case of
dry crops, e. g. straw) and to 25 bar / 362 PSI (in case of silage). Do not pick up the swath until
the set target bale channel flap pressure is reached in the terminal to ensure that the bale is
complete and to prevent the bale channel flaps from bending out of shape.
Press two bales in manual mode to fill the bale channel completely.
To always achieve the same solidity of bales automatically with materials of different properties
(for example with differing moisture content of materials on the same field), you should then
switch into Automatic mode.
In automatic mode, the target force of pressure must be set to a high enough level so that the
bale has the desired bale firmness.
The contact pressure of the bale channel flaps in the bale channel is controlled automatically by
the job computer so that the pre-selected baling force is reached.
As the material becomes moister, it becomes more difficult to compress the bales. Because of
this, the bale channel flap pressure is reduced somewhat. As the material becomes drier, the
bale channel flap pressure increases again. Thus the pressure display may deviate significantly
in the display. Bale quality and bale firmness remain constant.
Starting with full bale channel
Do not switch to automatic mode until the target bale channel flap pressure has been reached in
manual mode.
If baling should be done in manual mode, do only pick up the swath if the target bale channel
flap pressure has been reached.
Pos: 55.16 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
