Settings
286
Pos: 109.45.10 /B A/Einstellung en/Großpackenpre sse/MutiBale/ Einstellung Gummipuffer z wischen den Nad elschwingen @ 24\mod_124 1501934539_7 8.docx @ 24 5332 @ 3 @ 1
19.5.6 Setting the rubber pad between the needle yokes
Fig.
Setting the distance U
By adding or removing compensation washers (16) between the rubber pad (17) and the needle
yoke (18) the spacing is increased or decreased.
Note
After having set the rubber pads, the setting of the stop has to be checked (refer to chapter
"Setting the stop”).
Pos: 109.45.11 /B A/Einstellung en/Großpackenpre sse/MutiBale/M ögliche Einstellf ehler und d eren Behebung (M ultiBale) @ 24 \mod_12 41502437023 _78.docx @ 24535 6 @ 3 @ 1
19.5.7 Possible setting errors and their elimination (MultiBale)
Needle yoke (2) recoils back
out forward from the needle
yoke brake (1).
The spring (9) of the needle
yoke brake (1) is too weakly
tightened.
Tighten spring with more
torque.
Needle yoke brake (1) is
installed too far forward in the
direction of travel.
Install the needle yoke brake
further to the rear.
The stop (5) of the needle yoke
brake (1) is installed too far
forward.
Install the stop (5) further to
the rear
The tube (2) of the needle
yoke (3) is not running over the
infeed surface (7) into the
needle yoke brake (1).
Spring (9) of the needle yoke
brake (1) is overtightened.
Tighten spring less tightly.
Needle yoke brake (1) is
installed too far back in the
direction of travel.
Install the needle yoke brake
further forward.
The journal (12) of the needle
yoke (14) is not reliably seized
by the locking (11).
The needle yoke brake (1) or
the stop (5) is installed too far
back in the direction of travel.
Install the needle yoke brake
(1) or the stop (5) further
forward.
Setting of needle connecting rod
not correct.
Correct the setting of the
needle connecting rod.
Pos: 109.46 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
