Krone Big Pack 890 XC - Setting the Twine Brake

Operation
268
Pos: 107.34 /Übers chriften/Übersc hriften 2/A- E/BBallenausschi eber bedien en @ 168\ mod_136853547105 1_78.docx @ 1 458201 @ 2 @ 1
18.5 Operating Bale Ejector
Pos: 107.35 /BA /Sicherheit/2. Vor angestellte Warnhinweise/Warn ung - Verlet zungsgefa hr, wenn bei lauf endem Traktorm otor Funktionen dir ekt an der M aschine ausge @ 274\mod_ 14043048775 68_78.docx @ 20 64063 @ @ 1
WARNING!
There is an increased risk of injury if functions are performed directly at the machine
while the tractor engine is running.
If functions are performed directly at the machine while the tractor engine is running, people
standing in the danger zone can be crushed or killed.
• Only operate the machine while the tractor engine is running if
– The PTO shaft is switched off and coasting machine parts have come to a standstill.
– The tractor is secured to prevent it rolling away.
– The parking brake and the flywheel brake on the machine are applied.
– The person operating the machine knows which functions are executed by the various
operations.
– The person operating the machine is standing outside the radius of action of the
moving parts of the machine.
– No other persons are standing in the danger zone.
Pos: 107.36 /BA /Bedienung /Groß packenpress e/Ballenaussc hieberBallena usschieber bedie nen Medium-El ektronik @ 3 56\mod_1438 688367779_78. docx @ 2653130 @ @ 1
Operating the bale ejector with the medium electronics version
Fig.
169
Position a = move out bale ejector
Position b = move in bale ejector
• Actuate the control unit ( ).
• Open shut-off valves (2) and (3).
Moving out bale ejector
Tighten the safety sleeve (4) and move the control lever (5) up into position (b).
Moving in bale ejector
Tighten the safety sleeve (4) and move the control lever (5) down into position (a).
Pos: 107.37 /BA /Bedienung /Groß packenpresse/ Ballenausschie ber/Hinweis: B allenausschi eber nach vorne verf ahren @ 15 7\mod_13 64368277097_78. docx @ 13863 84 @ @ 1
Note
After ejection of the bale it is absolutely essential to move the bale ejector to the forward
position and to close the shut-off valves (2 and 3).
Pos: 107.38 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1