Terminal – Machine Functions [Medium/Comfort Version Electronics]
179
Pos: 103.66.16 /Üb erschriften/Üb erschriften 2/A- E/A/Anzahl der MultiBale ein stellen @ 381 \mod_1444048 980340_78.doc x @ 2750144 @ 2 @ 1
14.25 Setting the number of MultiBales
Pos: 103.66.17 /B A/Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grun dbild Handbetri eb/Einstellen der M ultibaleanzahl Handbetrieb Bil d HS Baureih e @ 353\m od_14377197825 59_78.docx @ 2641172 @ @ 1
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
1/2
Fig.
Pos: 103.66.18 /B A/Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grun dbild Handbetri eb/Einstellen der M ultibaleanz ahl Handbetrieb @ 282\mod_ 1406529245316_ 78.docx @ 2 171682 @ @ 1
CAUTION! - Mixture of total bale and MultiBale
The MultiBale number should only be changed at the beginning of a bale. Doing so could result
in a mixture of total bale and MultiBale.
Note
First, set the bale length. Minimum length of the MultiBale: 45 cm (17.7 inches).
Pos: 103.66.19 /B A/Info-Center/CCI- ISOBUS-T erminal/CCI-BiG Pack/Grun dbild Handbetri eb/Anzahl der Mul tibaleanzahl einstellen Hand- und Automati kbetrieb @ 3 81\mod_144404 9233292_78. docx @ 2750206 @ @ 1
Setting the number
The bale length has been set, see chapter Terminal – Machine function "Setting bale length
(manual and automatic mode)".
• Change the value, see chapter Terminal – Menus, "Changing the value".
Pos: 103.67 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
