Krone Big Pack 890 XC - Moving Baling Ram into Position

Settings
283
Pos: 109.41 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Oberer Totpunkt der Na deln @ 21\ mod_1239093 619118_78.docx @ 228856 @ 3 @ 1
19.4.3 Top dead centre of the needles
To be able to check the upper dead point of the needles, turn the needle yoke up to its highest
position (dead centre point) (II). The needles (4) protrude out from the knotter. The distance "b"
between the upper edge of the drive disc (2) and the mid-point of the lower roll on the needle
point should be at least b = x mm with twine. If the setting is not correct, it should be corrected
by shortening or lengthening the needle connecting rod (3). The needles should not touch the
cleaners (6) of the tappet (2) in their highest position.
Pos: 109.42 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Oberer Totpunkt Mass b Einachknoter und Doppelknoter @ 21\ mod_1239093730 930_78.doc x @ 228880 @ @ 1
Single knotter: b = 120 - 130 mm
Double knotter: b = 105 - 115 mm
Pos: 109.43 /BA /Einstellunge n/Großpackenpr esse/Nadeleinstellu ngen/Hin weis: Totpunkt der N adeln @ 30 2\mod_14139 75891941_78.d ocx @ 2353970 @ @ 1
Note
During tying process, dimension b must be checked manually as the difference when moving
up the knotter needles with or without twine may be ≥ 10 mm.
Pos: 109.44 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1