Krone Big Pack 890 XC - Page 324

Settings
324
Pos: 109.98.31 /Üb erschriften/Üb erschriften 3/P- T/TTastschwi nge versetze n @ 107\mod_13342 24192633_78.d ocx @ 964517 @ 3 @ 1
19.19.7 Adjusting the feeler rocker
Pos: 109.98.32 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih e/Voreinstellu ng Gewindest ange Anschlag Ac htung bei Ausf ührung Multi- Bale @ 272\m od_14032601 39102_78.doc x @ 2050144 @ @ 1
ATTENTION! Damage to the machine
To avoid damaging the machine, never change the position of the feeler rocker (1) on the
MultiBale version.
Pos: 109.98.33 /B A/Einstellung en/Großpac kenpresse/Varia bles Füllsyste m VFS/HS-Baureih e/Tastsch winge versetzen BiG Pack 890/1 270/1290 HDP @ 3 52\mod_ 1437545199994 _78.docx @ 263 7075 @ @ 1
Install the feeler rocker (1) in positions (I-II) depending on the bales produced.
Pos: 109.98.34 /B A/Einstellung en/Großpac kenpresse/Variables Füllsyste m VFS/HS-Baureih e/Voreinstellu ng Gewindest ange Anschlag Ac htung @ 369\ mod_144178 4070895_78.doc x @ 2703415 @ @ 1
ATTENTION! Damage to the machine
To avoid damaging the machine, never move the threaded rod (2) into position (VI).
Pos: 109.98.35 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih e/Auslösee mpfindlichkeit Hin weis Tastschwi nge versetzen_ BP 890/1270/1 290 @ 369\m od_144178984 8892_78.docx @ 2703477 @ @ 1
Note
If the bale shape is still not satisfactory after the spring has been tensioned to the maximum,
install the feeler rocker in the next higher position.
If the overload protection still responds too frequently after the spring tension has been reduced
to the maximum, install the feeler rocker in the next lower position.
Pos: 109.98.36 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/H S-Baureih eVoreinstell ung Gewindesta nge Anschlag Bild HS-Baureih e @ 352\mo d_14374884020 20_78.docx @ 2 636918 @ @ 1
IV
III
II
I
1
2
17
VVI
Fig.
230
Pos: 109.98.37 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/ BiG PACK 4x4/Tastsc hwinge versetzen Hi nweis 1 @ 1 07\mod_1334 224608802_7 8.docx @ 964632 @ @ 1
Note
Only move the feeler rocker (1) if the triggering sensitivity can no longer be adjusted with
the spring (14) (see Settings section “Adjusting the triggering sensitivity”).
Pos: 109.98.38 /B A/Einstellung en/Großpackenpre sse/Variables Füllsystem VFS/ BiG PACK 4x4/T astsch winge versetzen Han dlungsanweis ung 1 @ 10 7\mod_13342 24662927_78.d ocx @ 964660 @ @ 1
• Loosen the hexagonal head screw (17)
• Move the feeler rocker (1) into the required position
• Tighten the hexagonal head screw (17)
Pos: 109.98.39 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1