Settings
281
Pos: 109.32 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Nadel einstellung ÜS @ 21\mod_1 23910386704 0_78.docx @ 229 569 @ 2 @ 1
19.4 Setting the needles
Pos: 109.33 /BA /Einstellungen/Gr oßpackenpress e/Nadeleinstellu ngen/Seitlich e Einstellung der Nadeln ÜS @ 25\mod_1 24236949705 6_78.docx @ 2535 21 @ 3 @ 1
19.4.1 Lateral setting of the needles
Pos: 109.34 /BA /Einstellungen/Gr oßpackenpr esse/Nadeleinst ellungen/Acht ung Einstellung en der Nadel / Na delschwinge nic ht überprüft @ 21\mod_1 23910393772 7_78.docx @ 229 593 @ @ 1
CAUTION! – After setting the needles / needle yoke not checked
Effect: Considerable damages to the machine
After setting the needles pass once manually through the tying process. In doing so, the
needles and needle yoke must not come in contact with the frame, baling ram or other parts
during the upward or downward motion.
Pos: 109.35 /BA /Einstellungen/Gr oßpackenpr esse/Nadeleinst ellungen/Seitlich e Einstellung der Nadeln @ 21\mod_1239 091172524_7 8.docx @ 228761 @ @ 1
Fig.
Place the needles (1) so they are centered in the oblong holes of the needle yoke, align then
with the needle slots in the bale channel chamber floor and fasten them in place with the screws
(2).
• Trigger the tying process manually with machine at a standstill
• Turn the needle yoke manually on the flywheel in working direction upwards until the
needles are taken up into the needle slots of the baling ram
• Tighten the flywheel brake to lock the needles in this position
• In this position move the baling ram to the side with a mounting lever to check whether the
needle may possibly be touching the needle slots of the baling ram on the side
• If necessary, loosen the screws (2)
• Align the needles to the needle slots of the baling ram and tighten the screws (2)
• Loosen the flywheel and turn the needle yoke manually on the flywheel further upwards into
working position (the needles must be taken up in the centre of the channel slots during
rising and they must slightly be positioned on the knotter blocks in direction of travel lateral
right)
If that is not the case:
• Tighten the flywheel brake to lock the needles in this position
• Loosen the screws (2)
• Align the needles to the channel slots and tighten the screws (2)
Pos: 109.36 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
