Krone Comprima F 155 XC - 11.13 Setting Bale Diameter

Operation
143
Pos: 48.77 /Übersc hriften/Überschrif ten 2/A-E/ B/Ballendurch messer einstellen @ 426\mo d_14549274645 15_78.docx @ 2 954557 @ 2 @ 1
11.13 Setting Bale Diameter
Pos: 48.78 /Ab kürzungen /Abkürz ungen sprac hneutral/Rundb allenpressen/Co mprima F 155 (XC) @ 79\ mod_131469032 5737_78.doc x @ 697640 @ @ 1
Comprima F 155 (XC)
Pos: 48.79 /WHB/ Grundeinstellu ngen/Rundballe npresseEinstell en des Ballend urchmessers_C omprima F, CF, CF X-tre me_Ultima @ 404\mod_14490 71918337_78.d ocx @ 287155 1 @ @ 1
The tailgate must be closed and the bale chamber must be empty.
Adjust the bale diameter at the rear right and left of the machine.
CPN00010_3
1
3
2
Fig.
114
Upper hole = Smallest bale diameter
Lower hole = Largest bale diameter
• Detach the split pin (2) from the locking bolt (1) on the spring tube (3).
• Insert the locking bolt (1) into the desired bore on the spring tube (3) and secure with the
split pin (2).
Note
The setting must be the same on both sides.
Pos: 48.80 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1