Krone Comprima F 155 XC - 7.19 Menu 9 “Filling correction”

Terminal menus 7
Menu9 “Filling correction” 7.19
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 49
Changing mode
 Call up and save mode, refer to page38.
The following modes can be selected:
Icon Explanation
Net wrapping
Chamber film wrapping
7.19 Menu9 “Filling correction”
If the bale diameter is not achieved or is too high, the filling correction can be used to correct
the bale diameter within a predefined range (bale size -10to +10cm).
n
+
-
9
10
-10
0
cm
+
-
EQG003-018
ü For The menu level is active, refer to page36.
 To open the menu, press
+
-
.
Æ The display shows menu “Filling correction”.
Adjusting the filling correction
 Increase or decrease the value, refer to page37.
 To save the value, press
.
Example
The set target bale diameter is 108 cm.
If the actual bale diameter is only 100 cm and thus 8 cm too small, a correction value of + 8 cm
must be set.
This means:
Correction value=target bale diameter - bale diameter