Settings
195
Pos: 50.14 /Übersc hriften/Üb erschriften 2/A-E/D /Drahtseil für "G arnbremse lös en" einstellen @ 343\mod_ 14331683014 66_78.docx @ 2 595517 @ 2 @ 1
12.10 Adjusting the wire rope for "Loosen twine brake"
Pos: 50.15 /Übersc hriften/Zwisch enüberschrifte n/A-E/Bei A usführung Garn- und Netzbindu ng @ 335\mo d_142961846475 0_78.docx @ 2552971 @ @ 1
With twine tying and net tying version
Pos: 50.16 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Drahtseil für "Garnbre mse lösen" einstell en_Einl eitung_Compri ma @ 344\mod _1433250717478 _78.docx @ 2598501 @ @ 1
The wire rope is located below the side guard on the right-hand side of the machine.
Pos: 50.17 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Garnbr emse lösen eins tellen_Garn_C omprima_ Bild @ 346\mo d_143461982 3375_78.docx @ 2 609473 @ @ 1
Fig.
Pos: 50.18 /Übersc hriften/Zwisch enüberschrifte n/A-E/Bei Ne tzmotor in Mittels tellung @ 346\mod_14346 21930718_78.d ocx @ 260963 9 @ @ 1
With net motor in central position
Pos: 50.19 /BA/Be dienung /Ru ndballenpresse/G arnbindung Co mprima/Garnbr emse lösen eins tellen_Netzm otor in Mittelstell ung1_Compr ima @ 346\ mod_14346203 73789_78.doc x @ 2609514 @ @ 1
Fig.
• On the operator terminal in the "Manual operation" menu, move the clamping arm (5) from
the net motor extended position to the central position.
Pos: 50.20 /BA/Be dienung /Ru ndballenpresse/G arnbindung C omprima/Gar nbremse lösen einstellen_Netz motor in Mittelstell ung2_Text @ 346\mod_14 34626532221 _78.docx @ 26 09728 @ @ 1
The sensor (7) is covered by the sensor guard. In this position, the ball bearing (2) must be at
the upper arrow on the cam track (4).
In this position
- the tension spring (3) must not be tensioned,
- tension on the wire rope (6) must be slightly released.
• If necessary, adjust the length of the wire rope (6).
Pos: 50.21 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
