Krone Comprima F 155 XC - 17.2 Before the Start of the New Season

Placing in Storage
278
Pos: 60.7 /BA/Einl agerung/Einl agerung_Am En de der Erntesais on_text-hin weis_Instands etzungsarbeiten notieren @ 47 1\mod_14719 32287828_78.d ocx @ 3184395 @ @ 1
Note
Write down all repair jobs which must be performed by the next harvest and arrange for them
to be done with sufficient lead time. Your KRONE dealer is better able to perform maintenance
service and any required repairs outside of harvest season.
Pos: 60.8 /Übersc hriften/Zwisc henüberschriften/F -J/Isolier band auf die Bre msscheibe kle ben @ 491\mod_ 14853574457 18_78.docx @ 3296790 @ @ 1
Gluing insulating tape onto the brake disc
Pos: 60.9 /BA/Einl agerung/Modulg ruppen/Run dballenpressen/Is olierband von der Bremssc heibe entfern en_Bild @ 514\ mod_15040967 60033_78.doc x @ 3534793 @ @ 1
COM00617
1 2
Fig.
230
Pos: 60.10 /BA/Ei nlagerung/Run dballenpress en/Einlagerung _Am Ende der Er ntesaison_Bi ndematerialbr emse Isolierband_t ext_ALLE RP @ 491\mod _1485357778 318_78.docx @ 3 296821 @ @ 1
• Mask the brake surface of the brake disc (2) with insulating tape (1) to prevent corrosion at
the wrapping material brake.
Pos: 60.11 /Übersc hriften/Überschrif ten 2/U-Z/ VVor Beginn d er neuen Saiso n @ 0\mod_11 97386024448 _78.docx @ 20 081 @ 2 @ 1
17.2 Before the Start of the New Season
Pos: 60.12 /BA/Sic herheit/3. Sic herheitsroutine n/Maschine für Instandhaltungs- , Reparatur- , Wartungs- un d Einstellarbeite n vorbereiten @ 272\mod_ 1403522290336_ 78.docx @ 2 051115 @ @ 1
WARNING!
Risk of injury during repair, maintenance and adjustment work on the machine.
If the machine has not been shut down, the machine or machine parts may move
unintentionally. As a result, people may be seriously injured or killed.
If the machine is not supported securely, the machine or machine parts may roll, fall or drop. As
a result, people may be seriously injured or killed.
• Before starting repair, maintenance and adjustment work, perform the following steps:
• Shut down and safeguard the machine, see chapter Safety, "Shutting down and
safeguarding the machine".
• The raised machine or machine parts must be securely supported, see chapter Safety
"Securely supporting the raised machine and machine parts".
Pos: 60.13 /BA/Ei nlagerung/Run dballenpresse n/Einlagerung_ Vor Beginn der neuen Saison_Net zbremse Isolier band_ALLE RP @ 500\ mod_1493371 138167_78.docx @ 3438463 @ @ 1
• Pull off the insulating tape at the wrapping material brake, see chapter Initial
commissioning, "Preparing the wrapping material brake".
Pos: 60.14 /BA/Ei nlagerung/Run dballenpresse n/Einlagerung_ Vor Beginn der neuen Saison_Ru ndballenpress en @ 35\ mod_12561355 68894_78.doc x @ 326871 @ @ 1
• Before placing the machine in service again, trigger a tying or wrapping process and run
through it manually. As you do, check the functions of the starting devices of the tying or
wrapping process.
• Grease all lubrication points and oil the chains. Wipe away grease that comes out of
lubrication points.
• Check the oil level in the main drive gearbox and top up if necessary.
• Check hydraulic hoses and lines for leaks and replace them if necessary.
• Check all screws to make certain they are tight or retighten them if necessary.
• Check all electrical connection cables and the lighting. Repair or replace if necessary.
• Check the entire setting of the machine and correct if necessary.
• Check the operating functions.
• Re-read the operating instructions thoroughly.
Pos: 60.15 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1