Operation
155
Pos: 48.95.29 / BA/Bedienung /R undballenpresse/ Garnbindung C omprima/Garn führen nach G arnrollen3_Bild _Comprima @ 343\mod_ 1433145059696_ 78.docx @ 2 593740 @ @ 1
Fig.
Pos: 48.95.30 / BA/Bedienung /R undballenpresse/ Garnbindung C omprima/Garn führen nach G arnrollen3_Te xt_Comprima @ 343\mod _1433145061 066_78.docx @ 25 93771 @ @ 1
• Run the right two twines (2) from the twine brake through the twine guides (5) and over the
stepped pulley (1).
• Run the two twines (2) through the twine guides (3) and (6).
Make sure that the upper twine is run through the upper twine guide (3) and through the left
twine guide (6).
Pos: 48.95.31 / BA/Bedienung /R undballenpresse/ Garnbindung C omprima/Garn führen_Garn enden über G ummirolle_Te xt_Comprima @ 3 43\mod_143 3147654184_7 8.docx @ 25 93834 @ @ 1
• Place the ends of the twine between the rubber roller (4) and pressure roller with at least 25
cm overhang.
Pos: 48.95.32 /Ü berschriften/Ü berschriften 3/A- E/A/Anzahl d er Garnlagen ein stellen @ 346 \mod_1434708 881394_78.doc x @ 2610266 @ 3 @ 1
11.17.4 Setting the Number of Twine Layers
Pos: 48.95.33 / BA/Bedienung /R undballenpresse/N etz-Garn bindung/Anza hl der Garnlagen einstellen_Bild _Fortima @ 335\mod_142960 9904405_78.d ocx @ 255257 1 @ @ 1
Fig.
Pos: 48.95.34 / BA/Bedienung /R undballenpresse/N etz-Garn bindung/Anza hl der Garnlagen einstellen_Einl eitung_4-fac h Garnbindung @ 363\mod_143 9991555331_ 78.docx @ 2674 096 @ @ 1
The number of twine layers is set on the stepped pulley (1) in the twine box.
Pos: 48.95.35 / BA/Bedienung /R undballenpresse/N etz-Garn bindung/Tabelle Anzahl Garnlag en @ 363\ mod_143999162 0549_78.docx @ 2674383 @ @ 1
Pos: 48.95.36 / BA/Bedienung /R undballenpresse/N etz-Garn bindung/Anza hl der Garnumwic klungen einstelle n_Text_Forti ma_Comprima @ 335\mod_ 1429610071522 _78.docx @ 25 52602 @ @ 1
The diameter of the stepped pulley (1) must be smaller the longer the crop. Thus the round bale
is wrapped the less with twine.
Pos: 48.95.37 / Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0. docx @ 4165 @ @ 1